Skip to content
Notice: This website is intended for adults 18+ and over. We do not sell to minors. Find the best price by supporting and shopping at an authorized Echo1 dealer. All Airsoft guns ship with orange tips. Airsoft guns, knives, tools, and replica knives are shipped with ADULT SIGNATURE REQUIRED.
Notice: This website is intended for adults 18+ and over. We do not sell to minors. Find the best price by supporting and shopping at an authorized Echo1 dealer. All Airsoft guns ship with orange tips. Airsoft guns, knives, tools, and replica knives are shipped with ADULT SIGNATURE REQUIRED.

JAG Arms Extreme Active Braking MOSFET with wiring

Original price $70.00 - Original price $70.00
Original price
$70.00
$70.00 - $70.00
Current price $70.00

Extreme active brake with wiring

- professionally designed and manufactured mosfet with motor active braking with 500mm long wires on each side for airsoft electric guns (AEG)
- four high quality 1,5qmm (AWG16) power wires covered with silicon insulation and two 0,25qmm (AWG24) signal wires
- If you want to use your own wires, choose device without wiring.
- Active brake uses the excess energy from the motor to stop it. The braking effect is the most powerful with high torque motor
- in weapons with very high rate of fire (ROF) active brake solves multiple shots in semi mode
- in semi fire mode piston isn't partially stretched, spring is fully released, parts in mechbox aren't under strain and nozzle locks hop-up chamber in greater part (depends on ROF)
- in auto fire mode piston stops in random position due the mechbox design. But this stopping is much faster with active brake
- Active brake increases gun rate of fire and battery holds longer
- no sparking on switch contacts
- device has voltage stabilization for switch mosfet, mosfet is fully opened and makes less heat
- specified for common batteries up to 17 V (Ni-xx 8.4V - 14,4V, li-po 7.4V - 14.8V, li-fe 9.9V - 13.2V)
- designed for maximum spring M170
- switching mosfet handles up to 2.5 times bigger currents than it's cheaper variant
- 5 times better switch on resistance = lower mosfet heating
- massive cooler for heat dissipation, it is glued to mosfet
- braking mosfet handles up to 2.3 times bigger currents than it's basic variant
- doubled number of resistor for reducing braking effect = less resistors heating
- easy to understand 6 wires connection
- device size 53x21x13mm
- coated with lacquer, which protects device against water
- in package is heat shrink over device

WARNING: Installation of this device leave to expert, who could solder and disassemble airsoft gun. Never user soldering gun!